wirebond_title.gif

Wire DRC

Wirebond�s DRC insures that each bond wire falls within the limits set by the assembly engineer. Each wire is checked for length, angle, and spacing. Any violations are reported in a summary file. Wirebond also reports the longest and shortest wires and identifies which finger or ring they are attached to.

wrules_a.gif

wire_drc_2.gif

Setting up the DRC rules is simple. From the Wire DRC dialog the user defines the shortest allowable wire, the longest allowable wire, the spacing between wires (measured center-to-center) and the maximum angle measured normal from the edge of the die.

The user also configures the error markers by setting the size, shape and color for each of the 6 different errors.


wire_drc_6.gif

The Wire DRC module reports errors in two ways - graphically on the AutoCAD display (shown above) and as a text file (shown below).

The assembly floor will feel much better about the wire diagram if you are able to attach a report to the drawing showing the DRC rules and the fact that no errors were found.

wire_drc_4.gif


Page   |    1    |    2    |    3    |    4    |    5    |    6    |    7    |    8    |    9    |    10    |    11    |